#8-32 hole sizes: clearance, tap drill and heat-set pocket
A #8-32 screw takes a Ø0.196 in normal clearance hole, a Ø0.136 in tap drill, a Ø0.213 in printed free-fit hole, and a Ø0.224 in heat-set pocket.
#8-3232 TPI
Printed free-fit clearance hole — interactive in the app
Clearance hole (3D printed)
same grades as the drilled hole
Close fit
snug press fit · = 4.572 mm
Ø0.18 in
Free fit
easy assembly · = 5.41 mm
Ø0.213 in
Slicer hole compensation
typical FDM starting point — not included above
0.008 in
Heat-set insert
Pocket bore
install-hole diameter the insert melts into
Ø0.224 in
Pocket depth
short 0.225 · safe 0.382 in
0.352 in
Min wall
radial material around the insert
0.112 in
Head recess (3D printed)
Socket head cap
Recess bore
clears the head
Ø0.29 in
Head height
0.164 in
Tap drill
drill #29
Tap drill
for a tapped thread · = 3.454 mm
Ø0.136 in
Clearance hole (drilled)
Close fit
drill #15 · = 4.572 mm
Ø0.18 in
Normal fit
drill #9 · = 4.978 mm
Ø0.196 in
Loose fit
drill #3 · = 5.41 mm
Ø0.213 in
Counterbore
Counterbore
clears a socket-cap head
Ø0.3125 in
Counterbore depth
0.164 in
Min thread engagement
depth of thread to hold
Steel / hard
0.164 in
Aluminum / soft
0.246 in
Plastic / print
0.328 in
Identify an unknown screw
Major Ø range
caliper across the thread crests
0.159–0.164 in
Pitch check
threads per inch equivalent
32 TPI
These are standard reference numbers. Every machine prints and cuts a little differently — set a hole to Ø5.00 and it might land at Ø4.95. In the FitCheck app you calibrate your machine once, and every dimension here auto-corrects to match it — plus tolerance bands, more insert series, and full offline use.
Clearance holes come in three graded sizes. Close locates the part precisely and forgives nothing; normal is the default for most assemblies; loose buys alignment slop across multi-hole patterns. (The standards name the same three grades differently — ISO 273 calls them Fine/Medium/Coarse, ASME B18.2.8 Close/Normal/Loose; the plain-English set is used throughout this page.) The tap drill is a different animal: it leaves material for the thread, so it is always smaller than any clearance hole.
Why your printed hole comes out small
An FDM hole is walked out by the extrusion width and pulled in as the plastic cools, so a commanded Ø5.00 typically measures under. The printed clearances above are the same standard grades as the drilled ones — they are not pre-compensated. Close that gap either with your slicer's hole-compensation setting (the starting value is listed above) or, properly, per machine: print one test coupon, measure it, and the app applies your own measured error to every dimension on this page.
Heat-set inserts
The pocket bore is the hole the insert melts into; it is smaller than the insert so the displaced plastic fills the knurling. Too tight and the boss splits, too loose and the insert spins under torque. Keep the wall around it at least as thick as the value above.
Metric clearances per ISO 273 · imperial per ASME B18.2.8 · heat-set pockets per CNC Kitchen · bearing housing seats per ISO 286. Reference only — verify before you cut.